I just received my order. It appears to be MDF in the middle, not plywood. Is this accurate? Also there is no veneer on the side that would face the opening of the cabinet. You can see the MDF clearly. Shouldn’t the veneer be on all sides? View answer
Asked 1 ´year ago | Base Cabinet Organizers > Omega National Products Tra-Sta Cookie Tray Dividers 4/Set Maple TS2424
How can I purchase or obtain a pair of replacement pinion adapters? One was damaged (specifically the one with the metal clip) during install as they were very tight during insertion. View answer
Asked 1 ´year ago | Drawer Slide Accessories > Blum MOVENTO 763/769 Lateral Stabilizer Set Blum ZS7M686MU
Based on the part numbers, it appears that these are manufactured by RPC (Rockford Process Control). Per their drawing (https://rockfordprocesscontrol.com/wp-content/uploads/2018/01/B0158XX1APP-PILASTER.pdf), these (HD, heavy-duty?) pilaster standards are 21 gauge steel, not 17 gauge aluminum. This is actually thicker than K&V, which publishes 23 gauge steel for their 255 series. Could you please verify the actual material? View answer
Asked 1 ´year ago | Pilasters and Clips > WE Preferred B01-58241-174 24in HD Pilaster, Surface or Flush Mount, Bright Zinc
I recently ordered two pair of youngdale hinges and without understanding the overlay, I ordered the 3/8" overlay. They didn't fit as what I need is a 1/2" overlay. The closest I could find to my original design (87L) is this hinge. Unfortunately it is sold in quantities of 200. I need only 42 pairs. (94 total hinges). Is it possible to buy this hinge in lower quantities? I was able to buy two pairs of the 3/8" just to try them out. I bought the wrong one because I didn't understand the overlay but I believe I do now. View answer
Asked 1 ´year ago | Pin and Knife Hinges > Youngdale 87-200.AB Bulk-200 Pairs, Pin Hinge, 1/2 Overlay, Antique Brass
Hi, I would like to use this mechanism to make appliance garage. The space is under 15 inch wall cabinets and it is approximately 60 inch wide. Can I use this mechanism? Would the 12 3/8” inset be appropriate for the 15 cabinet above? What would be the maximum width of door I can use with this? View answer
Asked 1 ´year ago | Pocket and Flipper Door Slides > Sugatsune Soft-Close Mechanism-Inset 12-3/8" Single Type IF-102S-16
Can you tell me if these restrictors can be used with Kraftmaid cabinets using Blum hinges (The only identifying number I see is Blum 1 5/16).. And if not these restrictors, which model? View answer
Asked 1 ´year ago | Hinge Angle Restriction Clips > Blum Compact BLUMOTION 86 Degree Restriction Clip Blum 38C315B3.1
