Hi, I'm using the 563H 5339B 21 inch blum drawer slides. My client would like a heavier slide and I noticed this one the 769.5330s, does this have the same footprint as the one I have or would I have to rebuild the drawers? I used 5/8" maple on the drawer boxes. If not do you have a direct replacement that is heavy duty that would replace it. thank you. View answer
Asked 4 ´years ago | Undermount Drawer Slides > Blum 21" MOVENTO 769 Full Extension Soft-Close Heavy Duty Undermount Slide Blum 769.5330S
I am replacing my existing Blum slides with Blum soft-close slides. Will the existing locking devices work with the new slides or will I need to change them as well? View answer
Asked 3 ´years ago | Undermount Drawer Slides > Blum 21" TANDEM plus BLUMOTION 563F Undermount Drawer Slide Blum 563F5330B
Will this slide work as an undermount for a pull-out shelf/drawer that is 13 3/8 inside by 14 3/8 wide x 22 long x 3 inch high in a pantry with a face frame with a 15 inch wide frame opening and 16 1/2 internal width? I can provide sketch if needed. Need 75 lb min, soft close. View answer
Asked 3 ´years ago | Undermount Drawer Slides > Salice 21" Futura Full Extension Soft-Close Undermount Drawer Slide Salice A7555/533 CP6
I currently have brookhaven cabinets with the non-softclose drawer slides. The existing slides are Blum tandem 562h533-02a that has been discontinued. I would like soft close drawer slides. Is the blum tandem 563h5330-b the comparable replacement with the soft close? View answer
Asked 3 ´years ago | Undermount Drawer Slides > Blum 21" TANDEM plus BLUMOTION 563H Soft-Close Undermount Drawer Slide for 1/2" - 5/8" Drawer Side Blum 563H5330B
I need replacement slides for my kitchen drawer. My hardware appears to have an "L" and not an "A" with the following #'s 7555 / 533 0016. When I search your website I cannot locate this serial number with an "L". Can only locate the serial number with the "A". Will an "A" series with the same serial numbers work for replacement parts? Thank you Steve steve@sussmanshank.com View answer
Asked 2 ´years ago | Undermount Drawer Slides > Salice 21" Futura Full Extension Soft-Close Undermount Drawer Slide Salice A7555/533 CP6
The drawer will not close flush to the face frame. It is out 1/8"+. The slide bracket is mounted exactly 10MM (3/8") from screw hole center to front of the face frame. The slides are rear bracket mounted only. The obvious solution is to move the slide bracket inward but that leaves very little material in the faceframe for the screws. Drawers are 3/4" thick and sides are exactly 21". Work great, just won't fully close. Any thoughts? View answer
Asked 2 ´years ago | Undermount Drawer Slides > Blum 21" TANDEM plus BLUMOTION 563F Undermount Drawer Slide Blum 563F5330B
I have some large Drawers. will be around 60lbs when loaded. I am using blum 554H and they will not close the drawer empty The drawer size is 16Wx12Hx18D. Heavy with the decorative Drawer front. Can you recomend a stronger closing undermount? View answer
Asked 2 ´years ago | Undermount Drawer Slides > Blum 21" TANDEM EDGE 7/8 Extension Soft-Close Undermount Drawer Slide Blum 554H5330B01
