Which screws are needed for the hinges and base plates for my last order? the sku's are 11194475 11194413 It would have been nice to know the screws were not included. Disappointed with this especially after watching Jason's how-to video and he said screws were included. View answer
Asked 3 ´years ago | Concealed European Cabinet Hinges > 110° Tiomos Half Overlay Soft-close Hinge Dowel Grass F028138343228
I have the 33.3630 hinges installed on my cabinets & have replaced some with the 33.3600 hinge since the pressed-in anchors remained in place - just unscrewed the old hinge & installed new one. I don't seem to need replacement anchors #33.3630. What are your thoughts? View answer
Asked 3 ´years ago | Blum 110° COMPACT Hinge Self-Closing Screw-On Blum 33.3600
Are one or two rear mounting sockets included when ordering part #7951.VE300, SKU 10338616? I will need a total of 6 pieces for 3 drawers. View answer
Asked 3 ´years ago | Drawer Slide Accessories > Grass 7951.VE300 Narrow Rear Mount Socket for Grass Dynapro, Elite, & Dynamic NT Undermount Drawer Slides
I ordered some of these and you delivered them, but they were not for metabox. They were for wood sided drawers. I need for metabox. Looks like the slide part is the same, but the plastic trigger that screws to the box is not the triangle shaped one in picture above that goes on bottom of drawer. How do I get just that small part only? Need right away. I shipped job without them already. View answer
Asked 3 ´years ago | METABOX Blumotion > Blum BLUMOTION for METABOX Blum Z70.0320
What is exact width of item? I have a cabinet that is 16” deep and opening is 11.75” wide. This is the only cabinet door mounted pull out garbage I can find for reduced depth cabinet. I want to ensure it fits before buying. Thanks. View answer
Asked 3 ´years ago | Bottom Mount Trash Pull-Outs > Rev-A-Shelf 4WCSC Single 32 Quart Reduced Depth Bottom Mount Waste Container Maple Rev-A-Shelf 4WCSC-1532DM16-1
The top rail is pre-drilled for mounting. The bottom rail has nothing. I guess it's on me to drill holes? I don't understand the mounting plan here. View answer
Asked 3 ´years ago | Sliding Door Track Assemblies > 72" Roll-Ezy Track Sliding Glass Door Hardware Set for By-Passing 1/4" Glass Doors Knape and Vogt P992 ZC 72
The top rail has holes drilled for mounting. The bottom rail has nothing. I guess it's on me to drill holes? I don't understand the mounting plan here. Any suggestions on surface mounting to oak. I'm expected mounting holes. View answer
Asked 3 ´years ago | Sliding Door Track Assemblies > 72" Roll-Ezy Track Sliding Glass Door Hardware Set for By-Passing 1/4" Glass Doors Knape and Vogt P992 ZC 72
do you think a 20" slide would fit into the toe kick area of a 24" cabinet ? I'm making the cabinets so can tweak the dimentions a little, what is the minimum area required.? View answer
Asked 3 ´years ago | Side Mount Cabinet Drawer Slides > KV GS4260 20" Economy Push-to-Open Side Mount Full Extension Drawer Slide Zinc Knape and Vogt GS4260 20
