It would be great if Woodworkers Express would list the models of hinges that these and all of the hinge restrictors fit for certain brands by model numbers. I had to spend a couple of hours researching the correct hinge restrictors for the model of Salice hinge that I am using. Fortunately Rok hardware had the correct information to guide me to the correct product needed! I am mostly happy with Woodworkers Express, with this exception being a disappointing find. View answer
Asked 3 ´years ago | Hinge Angle Restriction Clips > Salice Universal Hinge Cabinet Angle Reduction Clip 90 ° Grey Salice SBA237X6
The drawer will not close flush to the face frame. It is out 1/8"+. The slide bracket is mounted exactly 10MM (3/8") from screw hole center to front of the face frame. The slides are rear bracket mounted only. The obvious solution is to move the slide bracket inward but that leaves very little material in the faceframe for the screws. Drawers are 3/4" thick and sides are exactly 21". Work great, just won't fully close. Any thoughts? View answer
Asked 2 ´years ago | Undermount Drawer Slides > Blum 21" TANDEM plus BLUMOTION 563F Undermount Drawer Slide Blum 563F5330B
Concerning the Rakks heavy duty bracket system, what is the minimum distance needed between the top of the C-Style wall mount and the ceiling, to allow the bracket to be inserted at the required angle? View answer
Asked 2 ´years ago | Shelf Standards and Brackets > C-Style Wall Mount Standard 84" Matte Black Rakks SC-084B
Can someone tell me what the 11 13/16" measurement is referring to? Also, Double Type vs. Single Type. Trying to compare this mechanism vs. Soft-Close Mechanism-Inset 12-3/8" Single Type Sugatsune IF-102S-16 . Thank you! View answers
Asked 2 ´years ago | Sugatsune Soft-Close Mechanism-Inset 11-13/16" Double Type IF-102W-14
Does it come in LH too? View answer
Asked 2 ´years ago | Brad Point Drill Bit 5/8" Dia x 7" Bosch B14609
What is the screw hole spacing on the standard? Specifically, how inset from the end of the standards are the top and bottom screw holes, and what is the spacing of the interior screw holes? View answer
Asked 2 ´years ago | Shelf Standards and Brackets > 82 Series 48" Double Slotted Shelf Standard Black Knape and Vogt 82BP BLK 48
I'm missing a small machine screw for the Blum Overlay CLIP. The clip has 84.355 stamped on the top and a -01 B on the bottom. What part do I order? View answer
Asked 2 ´years ago | Concealed European Cabinet Hinges > Blum 110° CLIP top BLUMOTION Full Overlay Soft-Closing Hinge Screw-On Installation Nickel-Plated 71B3550
Can these stays be used for a drop-down desk installation? I understand that the torque moment calculations are to coordinate the panel weight with the soft-down mechanism, but what are the absolute weight maximums? Once open, I presume the stay acts to support additional weight (as it would for a desk with items placed on the desk surface), but I don't see that spec anywhere. Thanks, Oliver H. View answer
Asked 2 ´years ago | Lid Supports and Stays > Sugatsune Heavy-Duty Soft-Down Stay RH White HDS-10HR/WHT
I want to use this on Ikea Akurum cabinets. I measure the drawer depth to be 20 inches including the front. This seems to be the right size to order. Any suggestions on what to actually measure? View answers
Asked 2 ´years ago | Blum TANDEMBOX Metal Drawer Boxes > Blum TANDEMBOX Lateral Stabilizer Set Dust Grey Blum ZST.500BA
