for these 16" brackets, is the inside flat dimension of the top of this bracket between the slotted wall channel and the raised tip on the end of this bracket 16"? or is it slightly less like 15.75 as there are common 16" shelf boards that are really only 15.75" wide that would lay flat? Trying to figure out what this dimension is so if I want to cut plywood for shelving boards what is the dimension that will lay flat and not lay on top of the raised bump at the end of these brackets? View answer
Answer posted 6 years ago | Shelf Standards and Brackets > 180 Series 16" Single Slotted Shelf Bracket White Knape and Vogt 180 WH 16
is there a way to make the caddy come out further before it bends? Mine hits my range and does not bend all the way and makes it awkward to get to the sliding shelves. View answer
Answer posted 6 years ago | Blind Corner Cabinet Organizers > KitchenMate Blind Corner Caddy with Swing-Out Motion Maple Omega National P0650MNL1
Hi - I have purchased SKU 4917 (00693-17) Left bracket and SKU 4918 (00694-17) Right Bracket for my Grass drawer slides. The Left bracket fits fine - however - right bracket does not fit at all (there is a lip on the bottom side of my current drawer slides, and a notch that this should fit in (on the old broken pieces) - SKU 4918 (00694-17) does not have this slit or slot that my drawer slides need. Any suggestions? Otherwise, the dimensions are great. The picture for 00694-17 shows a slot on the bottom side of the bracket (however, this picture is LEFT socket, not RIGHT). If it will help, I can send pictures of my current problem View answer
Answer posted 6 years ago | Drawer Slide Accessories > Grass 00694-17 Right Hand Plastic Rear Mount Bracket For 6600 Series Slides
What is actual description of this unit? Does it attach to air compressor? Does it come as shown or you have to buy parts separately like another client commented. I just like to know what I am looking at and what I am getting. TY. View answer
Answer posted 6 years ago | CA Tech 52-42 Mini Air Duster, Turbo
I have an extremely tall pantry, 97". I see you have extension polls that would let me hit my ceiling no problem, but this would leave a lot of empty space. Is it possible to connect this with a smaller, two shelf version? View answer
Answer posted 6 years ago | Full Round Lazy Susans > Rev-A-Shelf 18" Polymer Pantry Full Circle 5 Shelf Lazy Susan White Independently Rotating Rev-A-Shelf 6065-18-11-52
Approximately how many nails in 17107? View answer
Answer posted 6 years ago | Pilasters and Clips > KV 255-81N STB, 255 Series Pilaster Nails, Brown, Knape and Vogt
How many screws come in each pack? View answer
Answer posted 6 years ago | Shelf Standards and Brackets > 82 Series Screw Pack Zinc Knape and Vogt 82DP SCREW ZC
What is the width size? View answer
Answer posted 6 years ago | Table Legs and Bases > 2-1/2" x 2-1/2" Steel Folding Leg Bracket Selby S149L
for a 28" (w) x 13" (tall) horizontally mounted cabinet door with two hinges at the top, do you need a stay on each side of the door or will a single stay on one side be adequate to hold the door open? View answer
Answer posted 6 years ago | Lid Supports and Stays > Adjustable Soft-Down Stay for Upward Opening Door LH Nickel Sugatsune NSDX-35LK
Is this the same product as 11198229? View answer
Answer posted 6 years ago | Drawer Slide Accessories > Blum TANDEM Template Undermount Slides Blum T65160001
