Received the 1-1/8" snap in magnetic catch #555-P. Does it come in a size that is not as deep? This is for a vintage metal kitchen cabinet. The size fits in the location but is a little bit too deep. One a little less deep than the 13/16 would work better. Help View answer
Asked 2 ´years ago | Catches and Latches > 1-1/8" Snap in Magnetic Catch with Screws and Strike Aluminum Epco 555-P
I purchased one 18" x 14" 11" pullout basket, CB-181411CR-3 as a test and want to purchase about 11 more 7" and 11" high baskets. I want to attach to the shelves and NOT the side of the framed pantry cabinets. My contractor told me that the one that I sent him can only attach to the side. Can I attach these baskets to the shelves? View answer
Asked 2 ´years ago | Closet Baskets > Rev-A-Shelf 24" x 14" x 7" Pull-Out Wire Closet Basket Chrome CB-241407CR-3
I ordered some hinges described as Blum 39C355B.21 Compact BLUMOTION 39C Hinge, Soft-Close, 110 Degree, 1-5/16 Overlay, screw-on. These hinges did not have the Blum markings on them. Are these replacements for the Blum product or actual Blum products. They do not have the brushed nickel finish that my existing hinges have either. View answer
Asked 2 ´years ago | Concealed Compact Cabinet Hinges > Blum Compact BLUMOTION 39C Hinge Soft-Close 110 Degree 1-5/16 Overlay Screw-on Blum 39C355B.21
Did you recently move the screw hole? It used to be toward the bottom and now it’s toward the middle. Your image on the product page also has it toward the bottom View answer
Asked 2 ´years ago | Concealed European Cabinet Hinges > 165° Sensys Hinge Full Overlay Soft-Closing Screw-On Nickel Hettich 9099560
I just received my order. It appears to be MDF in the middle, not plywood. Is this accurate? Also there is no veneer on the side that would face the opening of the cabinet. You can see the MDF clearly. Shouldn’t the veneer be on all sides? View answer
Asked 1 ´year ago | Base Cabinet Organizers > Omega National Products Tra-Sta Cookie Tray Dividers 4/Set Maple TS2424
I noticed the part that sits on top of the fixed drawer rail only got fastened in one place... the front cabinet frame. This is because there is a gap where the back screw would be used. Is only one screw to hold in the actuator enough or would you need to use some kind of spacer allowing the second securing point? View answer
Asked 1 ´year ago | Drawer Slide Accessories > Titusoft Drawer Slide Soft Close Mechanism, Titusoft Face Frame, Titus Tool
I bought a couple of these to replace the cylinders in desk locks that have missing keys. Also purchased a master-key, assuming that could be used to remove the old cylinders. It does not. Can anyone tell me how to get the old lock plugs out? View answer
Asked 5 ´years ago | Lock Plugs and Cores > CompX Timberline LP-500-104TA Timberline Lock Accessories, Lock Plug, Keyed #104TA & Master Keyed, Bright Brass
