Hi, I would like to use this mechanism to make appliance garage. The space is under 15 inch wall cabinets and it is approximately 60 inch wide. Can I use this mechanism? Would the 12 3/8” inset be appropriate for the 15 cabinet above? What would be the maximum width of door I can use with this? View answer
Asked 10 ´months ago | Pocket and Flipper Door Slides > Soft-Close Mechanism-Inset 12-3/8" Single Type Sugatsune IF-102S-16
I recently ordered two pair of youngdale hinges and without understanding the overlay, I ordered the 3/8" overlay. They didn't fit as what I need is a 1/2" overlay. The closest I could find to my original design (87L) is this hinge. Unfortunately it is sold in quantities of 200. I need only 42 pairs. (94 total hinges). Is it possible to buy this hinge in lower quantities? I was able to buy two pairs of the 3/8" just to try them out. I bought the wrong one because I didn't understand the overlay but I believe I do now. View answer
Asked 9 ´months ago | Pin and Knife Hinges > Youngdale 87-200.AB Bulk-200 Pairs, Pin Hinge, 1/2 Overlay, Antique Brass
Based on the part numbers, it appears that these are manufactured by RPC (Rockford Process Control). Per their drawing (https://rockfordprocesscontrol.com/wp-content/uploads/2018/01/B0158XX1APP-PILASTER.pdf), these (HD, heavy-duty?) pilaster standards are 21 gauge steel, not 17 gauge aluminum. This is actually thicker than K&V, which publishes 23 gauge steel for their 255 series. Could you please verify the actual material? View answer
Asked 9 ´months ago | Pilasters and Clips > WE Preferred B01-58241-174 24in HD Pilaster, Surface or Flush Mount, Bright Zinc
How can I purchase or obtain a pair of replacement pinion adapters? One was damaged (specifically the one with the metal clip) during install as they were very tight during insertion. View answer
Asked 9 ´months ago | Drawer Slide Accessories > Blum MOVENTO 763/769 Lateral Stabilizer Set Blum ZS7M686MU
