Are side extensions available for this saw? View answer
Asked 2 ´years ago | Compact Table Saws > SawStop Compact Table Saw CTS-120A60
The depth of the track at the top is 3 .5 inches I only have 1 3/4 inches from the top of my garage opening to the 'ceiling' of my garage inside the cabinet Will this work? View answer
Asked 3 ´years ago | Tambour Doors and Tracks > Finger-Lite Tambour Door Track System 18-1/4" L Face Frame Brown Omega National T04019002-W01
I currently have brookhaven cabinets with the non-softclose drawer slides. The existing slides are Blum tandem 562h533-02a that has been discontinued. I would like soft close drawer slides. Is the blum tandem 563h5330-b the comparable replacement with the soft close? View answer
Asked 3 ´years ago | Undermount Drawer Slides > Blum 21" TANDEM plus BLUMOTION 563H Soft-Close Undermount Drawer Slide for 1/2" - 5/8" Drawer Side Blum 563H5330B
What shaft/hardware is needed to complete installation as pictured? Heading reads "post not included" Description reads "telescoping hardware included" ? Confusing?? View answer
Asked 2 ´years ago | D-Shape Lazy Susans > Rev-A-Shelf 22" Wood D-Shape 5 Shelf Only Lazy Susan Natural Maple Independently Rotating Rev-A-Shelf 4265-22-52
Do you offer these hinges in full set to include mounting screws? I just purchased these hinges on Amazon, and really like the performance, but the cost seems much higher sold in sets. Since this is only a partial hinge part, do you have a recommended hardware component that will complement this part number 175H5030.21. Appreciate your help since I need to purchase about 200 of these sets. Speaking of bulk purchase, do you have any discounts for them? Thanks in advance. View answer
Asked 3 ´years ago | Hinge Mounting Plates > Blum 9mm CLIP Inset Face Frame Adapter Mounting Plate with Cam Adjustment Screw-on Blum 175H5030.21
I read a review about the Rev-A-Shelf 53WC-2150SCDM-213 or 4WCBM-18DM-2 that said the opening mechanism pushes the trash shelf out all the way, as if you cannot just open it part way. Could you tell me if that is correct with these 2 models? I didn't see any other comments about that. I'd like to know before buying one. Normally a soft close door/drawer is just opened normally as far as you want and then it does a soft close. Thank you! View answer
Asked 3 ´years ago | Bottom Mount Trash Pull-Outs > Rev-A-Shelf 53WC Double 50 Quart Bottom Mount Waste Container Orion Gray Rev-A-Shelf 53WC-2150SCDM-213
The drawer will not close flush to the face frame. It is out 1/8"+. The slide bracket is mounted exactly 10MM (3/8") from screw hole center to front of the face frame. The slides are rear bracket mounted only. The obvious solution is to move the slide bracket inward but that leaves very little material in the faceframe for the screws. Drawers are 3/4" thick and sides are exactly 21". Work great, just won't fully close. Any thoughts? View answer
Asked 2 ´years ago | Undermount Drawer Slides > Blum 21" TANDEM plus BLUMOTION 563F Undermount Drawer Slide Blum 563F5330B