Question 1

I purchased a box of these to fit with 11370528 22 inch These don't slide into the back... no place for it. View answer

Asked 5 ´years ago | Drawer Slide Accessories > KV MUV-RBM Bulk-12, Rear Mount Bracket for KV MUV Sizes 14" & Up, Knape and Vogt

Question 2

How far from door edge should the cup hole set with 1/4" overlay hinge? Is 3 mm correct? Is the boring pattern the diameter of the cup hole? View answer

Asked 5 ´years ago | Concealed Compact Cabinet Hinges > Grass America 1/4" Overlay TEC 864 Wrap Mount Hinge Screw-on 04396-15

Question 3

Does the 230M5500 have self close or soft close View answer

Asked 5 ´years ago | Blum 22" Standard 230M Epoxy Drawer Slide White Polybag Blum 230M5500

Question 4

What is the best width for a stainless steel range hood? View answer

Asked 4 ´months ago | Stainless Steel Range Hoods

Question 5

does this work with KV 80 ANO 72, 72in 80 Series Single Slotted Shelf Standard, View answer

Asked 5 ´years ago | Shelf Standards and Brackets > 180 Series 20" Single Slotted Shelf Bracket Anochrome Knape and Vogt 180 ANO 20

Question 6

Does this kit come with a main support pole, if so what height is it ? Thanks View answer

Asked 5 ´years ago | Lazy Susan Hardware > Rev-A-Shelf Half Moon Two Shelf Pivot-Out Hardware Kit with Slides 6882-04-52

Question 7

Does the $30 fee apply if you have free shipping from Woodworker Express? If yes, is a $30 fee per order no matter the size of order? View answer

Asked 5 ´years ago | Drawer Side Blanks > Genesis Products 4" X 96" Vinyl Drawer Side 1/2" Thick White

Question 8

Do you carry the door bracket kit for this item? View answer

Asked 5 ´years ago | Bottom Mount Trash Pull-Outs > SCB 9" Single 20 Quart Bottom Mount Waste Container White Knape and Vogt SCB9-1-20WH

Question 9

What is the diameter of the hole needed to drill? View answer

Asked 5 ´years ago | Cabinet Knobs > Round Flush Pull 2-1/8" Diameter Polished Chrome Harney Hardware 36032

Question 10

Does the Amerock BPR3428ORB have any highlights on the finish View answer

Asked 5 ´years ago | Face Mount Hinges > Amerock 3/8" Inset Face Mount Self-Closing Hinge Oil Rubbed Bronze BPR3428ORB

Question 11

Do you have instruction sheet for mounting this latch? Do you need any special tools for mounting this latch? View answer

Asked 6 ´years ago | Specialty Locks > CompX C8384-KA-3, Chest / Lid Lock, Full Mortise, Bolt Type Hook (Travel 5/16

Question 12

What is the best control type for stainless steel range hoods? View answer

Asked 4 ´months ago | Stainless Steel Range Hoods

Question 13

Is this compatible with Blum Tip on (T60L7540 R+L) ? View answer

Asked 6 ´years ago | Bottom Mount Trash Pull-Outs > Rev-A-Shelf 4WCSC Double 35 Quart Bottom Mount Waste Container Maple 4WCSC-2135DM-2

Question 14

There seem to be 4 potential face frame mounting plates to fit this product, and I'd like to know which you'd recommend for my application. Blum offers a Center mount and an Off-Center mount in both the cam-adjustable and non-adjustable die cast style. Why would one choose the off-center mount rather than the center mount? My face frame, door and overlay are 3/4". Thanks! View answer

Asked 5 ´years ago | Concealed European Cabinet Hinges > Blum 155° CLIP top BLUMOTION Full Overlay Zero Protrusion Wide Angle Hinge Screw-on Installation Nickel-Plated 71B7550

Question 15

Will this fit the 71B7550 hinge (155 deg zero protrusion)? View answer

Asked 6 ´years ago | Blum 973A BLUMOTION for Doors Zero Protrusion Hinges Blum 973A7000

Question 16

Do the dowels come with this product or do they need purchased separately ? View answer

Asked 6 ´years ago | Concealed Compact Cabinet Hinges > Grass America TEC Adjustable Soft-Close Hinge Wrap Mount 1/4 Overlay Dowel 45mm Boring Pattern 02791A-15

Question 17

What are the best types to consider when purchasing a REVEGO duo product? View answer

Asked 3 ´months ago | REVEGO duo

Question 18

Why is application an important factor when choosing a REVEGO duo product? View answer

Asked 3 ´months ago | REVEGO duo

Question 19

What is the shortest valet rod available when in the closed position View answer

Asked 7 ´months ago | Valet Rods > Rev-A-Shelf 14" Deluxe Sliding Valet Rod Satin Nickel CVRSL-14-SN-1

Question 20

Does this "set" come as a single piece bracket, or is it a pair for both left and right sides of the door? View answer

Asked 5 ´years ago | AVENTOS HK top Lift System > Blum AVENTOS Mounting Plate with Bracket Set for use with Large Overlay Five-Piece Doors Blum 20S4F01

Question 21

Why is compatibility an important specification when choosing solvents? View answer

Asked 4 ´months ago | Solvents

Question 22

Do you have an installation guide for Omega National Interior Ductwork Kit for Broan Ventilators 250/390 CFM, 90358DUC1? View answer

Asked 5 ´years ago | Interior Ductwork Kit for Broan Ventilators 250/390 CFM Omega National 90358DUC1

Question 23

I have a 18” cabinet with a 15” opening and a Rev-A-Shelf Metal Pull Out Trash Can Mounting Kit that measures 13 3/8” available width. Does the hamper narrow enough at the bottom to fit? View answer

Asked 6 ´years ago | Pull-Out Laundry Hampers > Rev-A-Shelf Replacement Hamper Basket for HPRV1520 Series White HPB-03323-52

Question 24

Is this product steel or aluminum View answer

Asked 5 ´years ago | RTA and System Fittings > Titus 006401.885.001 Bulk-100, System 6 Dowel (Panel to Panel Applications, Screw-In), 9mm Drilling Length for Dowel Thread, Zinc

Question 25

What drill bit size do I need? View answer

Asked 5 ´years ago | AVENTOS HK top Lift System > Blum Hinge TIP-ON In-Line Adapter Plate for Standard Doors White Blum 956.1004

Question 26

What’s the door opening to fit this shelf View answer

Asked 5 ´years ago | Blind Corner Cabinet Organizers > CORNERSTONE Swing Scalea Blind Corner Pull-Out for 21" Opening Carbon Steel Gray/Maple Vauth-Sagel

Question 27

Is there adhesive on the edge banding woodtape? if so, is this heat activated or pressure? View answer

Asked 5 ´years ago | PVC Edgebanding > PVC Edgebanding Sunday Stroll 15/16" X .020" 600 L/F Roll Woodtape 30759EFM-1520-1

Question 28

which lock plug works with this body? View answer

Asked 5 ´years ago | Lock Bodies > CompX Timberline CB-250 Lock Cylinder Body Only, Deadbolt Lock, Double Door Lock, Surface Mount, Lower left hand or upper right hand installation

Question 29

1 have 2- doors that are each 18" wide x 72" high. what do I need to order? View answer

Asked 5 ´years ago | Pocket and Flipper Door Slides > 8091 22" Pocket Door Slide Without Hinge Plates Black KV 8091SP EB 22

Question 30

Is a template and jig available for this hinge? What screws should I use? View answer

Asked 6 ´years ago | Concealed Compact Cabinet Hinges > 1/2" Overlay Compact Hinge Soft-Closing Dowel WE Preferred 0683114702961 300

Question 31

What are the installation requirements for sliding door locks? View answer

Asked 4 ´months ago | Sliding Door Locks

Question 32

what backplate works with C7P6AG9 by SALICE AMERICA, INC. View answer

Asked 5 ´years ago | Salice Silentia 110° Soft-Closing Hinge Full Overlay Screw-on Salice C7P6AG9

Question 33

Hi, what is the minimum cabinet ipening for this item, the product details says 18" but i have istallation instructions for i beleive for this unit says 15"? View answer

Asked 5 ´years ago | Bottom Mount Trash Pull-Outs > ENVI BMT Saphir 18" Double 50 Quart Bottom Mount Waste Container Carbon Steel Gray Vauth-Sagel

Question 34

Are these single or double? The picture shows both. View answer

Asked 5 ´years ago | Catches and Latches > Sugatsune Heavy Duty Magnetic Catch Anodized MC-0083

Question 35

Could you use wire shelving with this bracket? Suggestions for securing the wire shelving appreciated. View answer

Asked 6 ´years ago | Shelf Standards and Brackets > 14-1/2" Premier Heavy Duty Double Slotted Shelf Bracket White WE Preferred B01-56141-WH4

Question 36

I installed Series 200 165° Self-Closing Hinge Full Overlay Dowel Salice C2RFA99 that I ordered from you; however, i would prefer if the hinges were soft close. Does that exist? View answer

Asked 5 ´years ago | Concealed European Cabinet Hinges > Salice Series 200 165° Self-Closing Hinge Full Overlay Dowel Salice C2RFA99

Question 37

Will These brackets support a 40"x40" table or do I need a bracket that has an arm that attaches to the legs further down on the legs to keep them from unfolding. Michael Brinkley View answer

Asked 6 ´years ago | Table Legs and Bases > 2-1/2" x 2-1/2" Steel Folding Leg Bracket Selby S149L

Question 38

I just want to verify that 1 pair of slides is 2 slides (top and bottom of 1 door) Is this correct? View answer

Asked 5 ´years ago | Pocket and Flipper Door Slides > 8091 20" Pocket Door Slide Without Hinge Plates Black KV 8091SP EB 20

Question 39

What is the significance of pocket height in REVEGO duo products? View answer

Asked 3 ´months ago | REVEGO duo

Question 40

What are the best versions of REVEGO duo products and how do they differ? View answer

Asked 3 ´months ago | REVEGO duo

Question 41

Why does material matter when selecting a REVEGO duo product? View answer

Asked 3 ´months ago | REVEGO duo

Question 42

How much weight will this shelf system support? View answer

Asked 5 ´years ago | Kidney Lazy Susans > Rev-A-Shelf 28" Wood Kidney Lazy Susan Shelf Only Natural Maple Independently Rotating 4WLS401-28-52

Question 43

How deep must cabinet be.....does it come in white. I want to use it for toothbrushes etc View answer

Asked 5 ´years ago | Appliance Garages and Tambour Door Kits > Omega National Products 15" Face Frame Tambour Door and ST2 Track System Kit Maple CO2-SMA-1

Question 44

Do you have any Hanger rails that are 1 inch tall? View answer

Asked 6 ´years ago | File Drawer Frame Systems > Paramount 1058-B, Pendaflex Hanger Rails, One 72" Long Rail, 1/2 Tall x 72 L x 1/8 Thick, Black

Question 45

Are the slides on this model Blumotion or ball bearing? Description says ball bearing, but on the Rev-a-Shelf site this part number says Blumotion. View answer

Asked 5 ´years ago | Base Cabinet Organizers > Rev-A-Shelf 8" Wood Pullout Cabinet Organizer w/Soft-Close Maple 448-BC19SC-8C

Question 46

Why does this require a 5 1/2" opening on a face frame cabinet but a 5 9/16 on a frameless? I have a 5.5" frameless cabinet I would like to use this on. View answer

Asked 6 ´years ago | Base Cabinet Organizers > Rev-A-Shelf 5" Tray Divider/Foil and Wrap Organizer with BLUMOTION Soft-Close Maple 447-BCSC-5C

Question 47

This price is for one roll?? View answer

Asked 5 ´years ago | Utility Tapes > 3M Scotch Fine Line Tape 218 Green 2" x 60 yd 5.0 mil 51138947101

Question 48

can slats be modified to 32"? View answer

Asked 6 ´years ago | Tambour Doors and Tracks > Omega National Products V-Notch Wood Veneer Tambour Door 1/2" Slats Red Oak 36" W x 47-1/2" L V3-RO502

Question 49

Why don't you offer the matching Onyx Cover Cap for this Hinge, Blum part no. 70.1663? View answer

Asked 5 ´years ago | Concealed European Cabinet Hinges > Blum 110° CLIP top BLUMOTION Inset Hinge Screw-On Installation Onyx 71B3750-ONYX

Question 50

Which hinge plates go with these? View answer

Asked 6 ´years ago | Pie-Cut Corner with Bi-Fold Center Door Cabinet Hinges > Grass America 120° Nexis Pie Corner Hinge Screw-on 70139-10

Browse by Topic